hello everyone:
I just started learning this software，i do not know if I had installed this software correctly, I used the “makefile” file provided in the user’s source code to install. May I ask if the installation is completed after I run “make”, and do I need any other commands because I cannot use “make install”. And when running the “benchmark” file downloaded from the official website, do I need to copy the file into the “bin” directory where “castor-recon” is located.
I would be very grateful if you could give any advice.
Hi,
The installation process is described in section 3.4.1 (for UNIX) in the documentation:
In order to directly run the benchmarks, you just need to add the binaries to your environment as described in 3.4.1.4, then you should be able to run the benchmark from any location.
Hope this helps,
Thibaut
Thank you for your help 